Modifying the Sheetfile
Plot Menu › Generate
Select the cross section sheetfile.
Click on the Sheet File Editor button.
The sheetfile will open in the Sheet File Editor.
Once the sheet file is open, click on the Cross
Section tab (on top), and the the Layout
tab (at the bottom)
Right click on the "Display Layerworks" value
column, the default value will change to 'No', right
click again. The layerworks dialog will appear.
|
Draw Pavement Symbol |
Check
this to display the Pavement Design symbol on
the Cross Section drawing. |
|
X-Origin |
The
X-Coordinate of the Bottom Left hand side corner
of the symbol. |
|
Y-Origin |
The
Y-Coordinate of the Bottom Left hand side corner
of the symbol |
|
Scale Factor |
The
symbol will be scaled by this value when plotted |
|
Colour |
The pen
colour of the symbol. |
The values used for the X-Origin and Y-Origin will
vary depending on the scale and size of cross section.
Clicking on the preview tab in the Sheet File Editor
will show the position of the profile relative to the
cross section.
Once the changes have been made to the sheetfile, save
the sheetfile under a different name (keep the
original as a backup).
Generating the Plot
The new sheetfile will automatically be used when the
plot is generated.
Click Next and then Finish to generate
the plot.
A typical cross section including the pavement
profile created in the pavement designer. |
